Full Description

1.1This specification covers asphalt cements graded by viscosity at 60C [140F] for use in pavement construction. Three sets of limits are offered in this specification. The purchaser shall specify the applicable table of limits. In the event the purchaser does not specify limits, Table 1 shall apply. For asphalt cements graded by penetration at 25C [77F]. See Specification D946. If needed, volume corrections for asphalt cements should be made according to Practice D4311.

TABLE 1 Requirements for Asphalt Cement, Viscosity Graded at 60C [140F]Note 1-Grading based on original asphalt.

Test	Viscosity Grade
	AC-2.5	AC-5	AC-10	AC-20	AC-30	AC-40
Viscosity, 60C [140F], Pas	25 5	50 10	100 20	200 40	300 60	400 80
Viscosity, 135C [275F], min, mm/s	80	110	150	210	250	300
Penetration, 25C [77F], 100 g, 5 s, min	200	120	70	40	30	20
Flash point, Cleveland open cup, min,C [F]	165 [325]	175 [350]	220 [425]	230 [450]	230 [450]	230 [450]
Solubility in trichloroethylene, min,%	99.0	99.0	99.0	99.0	99.0	99.0
Tests on residue from thin-film oven test:
Viscosity, 60C [140F], max, Pas	125	250	500	1000	1500	2000
Ductility, 25C [77F], 5 cm/min, min, cm	100A	100	50	20	15	10

^AIf ductility is less than 100, material will be accepted if ductility at 15C [60F] is 100 minimum at a pull rate of 5 cm/min.

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Product Details

Published: 12/01/2012 Number of Pages: 3 File Size: 1 file , 72 KB Redline File Size: 2 files , 130 KB